![]() ![]() It has a serial port and a parrallel port, but no USB port (its too old). I am thinkng that since I own a CAS-Mate 6.52 key, I might as well use it if possible. The replacement, a Roland-24 is seemingly in mint condition, so I think I will be able to get some extended use out of it. Jim, you can setup CASmate to run on either LPT 1 or 2, or COMM 1 or 2. If you listed some of the paticulars of what your using such as Operating system. Maybe Im missing something here but I thought Casmate would only plot from a com port. If it is set to the wrong one you then need to go into your bios and set it there. My CASmate program is set-up on LPT1, which is the required port according to Scanvec.īolander you need to go into device manager and see if the port is set to ecp or epp. I never worker with add-on comm ports but i would think there is a section in the devices menu to set certain parameters. ![]() It sets the communication speed and singlebidirectional data transfer. Now im not a computer tech But from what i learned over the years with my plotter and Flexi (i used Casmate a long long time ago) The port settings in the motherboard should be set at ECP. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |